Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDie CV Boot Installation Mount Cone Tool kann bequem Zeit sparen und die Arbeitseffizienz verbessern. Wir glauben, dass es Ihre beste Wahl sein wird. Spezifikation: Gewicht: 250 g, Länge: 32,9 cm, Durchmesser oben: 11,5 mm, Durchmesser unten: 102 mm, Material: Kunststoff, Hinweis: Die manuelle Messung erlaubt Fehler ist +/- 1-3 cm. Lieferumfang: 1 x CV Boot Installation Mount Cone Tool
Najmeddine
Bewertet in Frankreich am 12. Januar 2025
Pas encore utilisé mais ça va servir pour pouvoir changer moi même mes soufflets de cardan ! Le matériau est costaud et les dimensions sont correcte . Plus qu’à l’utiliser ☺️
Client d'
Bewertet in Frankreich am 13. Juni 2024
première fois que j'utilise cet outil et aucun problème pour monté mon soufflet de cardan
Customer
Bewertet in Großbritannien am 16. September 2023
I am old school but not done a cv boot for years , no more cv boot for make and model, so I thought ok I just use the top of a road cone did not work. The cv could not be removed from shaft , so the only way was removing the inner boot to let the bearing come out . The only prob with that is some of the bearings don’t have anything holding in the needle bearings , so could end up more work and parts , so I bought this. Worked fine , tip for using oil the cone with engine oil or power steering fluid or whatever then turn the boot inside out of doing the outer boot , then slide the boot onto the cone on the bench and push till the cv boots just started to leave the end of the cone by 10mm/20mm and stop. The rubber grips the end and hold the boot in position , just ready to pop on . Then take the cone to the cv boot and it will pop on with hardly any effort. Works great just don’t try using a road cone , it don’t work👍
JOE T
Bewertet in Großbritannien am 9. September 2022
i had someone else Dow the Job but it didn't work JOE T
Mr G SWORD
Bewertet in Großbritannien am 14. Dezember 2021
Bought this to fit the CV gaiter on Peugeot 107 driveshaft.It’s a universal size (big) so I would say it’s suitable for most cars but I had to cut it down ( half the length) for little Peugeot hub.The cone is made of a rigid plastic which isn’t brittle so if you drop it it won’t crack and its smooth finish to slide the gaiter over the top is burr free.It’s a cheap tool that won’t break the bank and makes the job really easy.
Produktempfehlungen
80.08€
34 .99 € 34.99€