Ihr Warenkorb ist leer
Ihr Warenkorb ist leerCMT 191.008.11B - Fresa helic. z2 pos. c/rodam. s/d=6.35x25.4 hwm dx
Jspulcio
Bewertet in Italien am 9. Dezember 2023
Che dire…. Come sempre vai sul sicuro… spendi di più ma spendi una volta sola
SDS
Bewertet in den USA am6. Januar 2021
This is my first upcut spiral router bit, I have had it for several months and I wish iI had bought it earlier. I am using it for duplicating patterns, it cuts clean and the bearing seems to be high quality. I had researched CMT prior to purchasing this bit and after using it I will be purchasing more.
Wildcat88
Bewertet in den USA am3. August 2019
The small bearings on top were a concern since they appear to be smaller than the cutting portion . But the bit followed my guide perfectly with no issues. I used this bit for cutting a pattern on a 3/8' plastic kitchen cutting board. As long at your rough cut is very close to the final shape you should get a chatter free cut.
Northernbaker
Bewertet in Kanada am 8. Oktober 2015
This is a handy bit for use when using router patterns that have tight inside curves. Although less robust than the more common 1/2 inch shanked pattern bits, it will allow you to produce some interesting profiles that are not possible with the larger bits. Just keep its limitations in mind, slow down and avoid forcing the router.
Trooper T
Bewertet in den USA am14. Mai 2014
I have used these type of bits before but not the CMT brand. I use them for pattern cutting in 1/8in maonite and 1/2in MDF I got less than a foot of cutting in the MDF with one bit before it snapped. The second bit wasnt much better in the masonite. Both bits broke in the same spot right at the base of the cutter. I will look for whiteside bits in the future. CHEAP BITS....
Produktempfehlungen
35.71€
15 .99 € 15.99€