Ihr Warenkorb ist leer
Ihr Warenkorb ist leer
Grundlegende Parameter:
Produktname: Rückschlagventil
Material: hochwertiges Messing.
Eigenschaften:
1. Hergestellt aus massivem Messing, hat die Eigenschaften Korrosionsbeständigkeit, hohe Temperaturformbarkeit und geringe magnetische Durchlässigkeit.
2. Verhindern Sie Flüssigkeitsrückfluss.
3. Gute Abdichtung, kein Auslaufen, einfache Installation und Demontage.
4. Weit verbreitet in Kraftstoff/Luft/Flüssigkeit/Öl/Gas, Rohrleitungsanwendungen und Verbindungen, und kann in verschiedenen Messgeräten und Kollektoren verwendet werden.
5. Arbeitsdruck: 200 PSI
Lieferumfang:
1 x Rückschlagventil.
1 x Teflonband
Hinweis:
NPT-Gewindegröße ist eine Nennrohrgröße, und sie stellt nicht den tatsächlichen Durchmesser dar.
Kenneth Wilson
Bewertet in den USA am8. Dezember 2024
As many others said, mine has poor threading and won't connect without leaking (despite teflon tape etc).Also, the direction of flow is backward from what I need. I assumed it would allow flow from female end toward male end (as you would use it with an outdoor faucet), but that's not what it does. I see now that the product listing doesn't indicate either way.
Emoy
Bewertet in den USA am5. September 2024
It works as advertised but I will rethread the male end to NPS so I can attach a flexible water heater line to it.
Ralph E Foster
Bewertet in den USA am28. Dezember 2024
Even with large amounts of tape. I had to over tighten it to make it seal. Torqued to the point of breaking the part. Treads not well cut. It took a bit to get it together. It did stand up to be torqued past normal. It finally made up nicely.
Jerry Morrison
Bewertet in den USA am24. Februar 2024
Performance was excellent
Hippy Bryan
Bewertet in den USA am9. Dezember 2023
The valve spring seats the backflow prevention plate adequately, and is not adjustable for tension. The 1" NPT threads show damage after being cut, and numerous nicks show they rolled around in the parts bin and damaged the soft brass of the valve prior to being packaged and shipped. It probably would have threaded on ok with the provided teflon tape, but I chased out the threads and wiped out the brass shavings before installing on the inlet to a jet pump. The check valve is holding pressure well for my pump to not lose prime and it's not kicking back on from water backflowing to the tank.
Produktempfehlungen
