Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Spezifikation:
Material: Kunststoff + Metall
Farbe: als Bilder dargestellt
Gewicht: 121 g
Typ: Halbleiterrelais
Spannung im Aus-Zustand: 0,75 V
Maximaler Einschaltstrom (It (RMS)): 20
Gate-Trigger-Spannung (Vgt): 0,75
Gate-Trigger-Strom (Igt): 25
Kein Wiederholungsstoßstrom (Itsm): 25
Maximaler Haltestrom (Ih): 15
Betriebstemperaturbereich: 85
Umgekehrte Wiederholungsspitzenspannung: 480
Aus Geschwindigkeit: Normal
Anwendung: Solid State
Paketliste:
1 * Halbleiterrelais
C. De Courcy-bower
Bewertet in Spanien am 31. Januar 2025
Does what it says. A perfect replacement for a burnt-out relay and completely silent. exactly what we needed for our kiln.
dominique
Bewertet in Frankreich am 2. April 2025
Très bon produit conforme à ma demande
dndtp
Bewertet in Deutschland am 24. August 2022
Works as advertised.Used for driving the electric heating coils in a small metal sintering setup
Fabio
Bewertet in Italien am 8. Februar 2021
Rilascio il feed in ritardo in quanto non lo avevo ancora utilizzato..sono circa 7 gg che sta funzionando correttamente, in piu ha un led rosso che indica lo stato di funzionamento.Led rosso fioco, rele alimentato in standby, NALed rosso intenso, rele funzionante, NC.Il carico collegato 230Vac/500W è sotto dimensionato, quindi non scalda.
Bombinho
Bewertet in Großbritannien am 13. September 2020
After less than 1h hour of use the SSR went up in smoke. Not what you would think in the first place, on the load side but the input side could not deal with mains input. The LED did not give away any hint of being overloaded and was fairly dim, rather insisting a cautious design. Instead the top left hand side of the SSR is visibly melted and the input circuit is now completely open. The load it was supposed to switch was a power supply with around 30W.But as aforementioned, the load circuit still gives a reading of ~30 MOhm, and from watching tear down videos the triac sits below the PCB on the cooling plate. That just leaves the conclusion that this SSR was not properly designed to be controlled by 240V at all or had been badly manufactured. The melt down happened above the board on the top of the SSR and therefore outwith any possibility to avoid this problem with better cooling without tearing the SSR down.
Milli
Bewertet in Deutschland am 5. Dezember 2019
super
K. Royle
Bewertet in Großbritannien am 4. August 2019
Simple solid state relay, which operated perfectly within the voltage and power ranges set.Convenient mounting holes and very good connectors made it easy to incorporate.
Produktempfehlungen
