Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktbeschreibung
Der robuste Trolling-Motorverbinder hat ein positives Snap-Lock-Design für 6- bis 12-Gauge-Draht. Das Kit enthält zwei Steckerhälften, vier Kontakte und vier Lötstecker zur Sicherung von Drahtleitungen in Kontakten (Draht nicht im Lieferumfang enthalten).
Set enthält:
1 x Schleppmotorstecker
Customer
Bewertet in Kanada am 21. August 2020
exactly as described
Alberta Sky
Bewertet in Kanada am 15. Januar 2018
Worked for what I needed them for. For quality; they compare to the ones I have seen from the OEM manufacture. They are probably the same ones.
Anonymous
Bewertet in den USA am11. August 2017
Works well if installed correctly! There are a couple videos showing incorrect installation and you will end up melting the connection on first use! If they do not connect well together and slide apart easily, the wires are installed WRONG. You can find same brand much cheaper from other electrical sights searching for 'Anderson Quick Disconnects.'
Customer
Bewertet in Kanada am 22. September 2016
A GOOD HOOKUP SYSTEM -- PICTURE INSTRUCTIONS FOR CORRECTLY INSERTING THE LEADS WOULD HELP WHEN PUTTING WIRES INTO EACH PLASTIC HOLDERS
Big Daddy
Bewertet in den USA am13. Juli 2016
This is great. I should have got it a long time ago. Some have argued it's hard to figure out. If you can't figure this out then you have no place on a boat or fishing. It is really simple. For those who claimed it melted, there is no way for this to melt unless you use too thin of a wire. Use 6 or 8 gauge wire and solder them and your good to go (home depot and lowes sells them for around 2$ a foot). Use solder connections to conned them to the battery and you will have years of use out of this. I recommend an inline fuse for safety reasons. I used a 60 am for a 55# trolling motor as Minn Kota stated.
Produktempfehlungen
2,683.00€
99 .00 € 99.00€
206.99€
90 .99 € 90.99€