Although it says it is for a Ranger 2019-2024 it does not fit the 2024. The hook is not long enough to clear the hood. Other than that it is well built and good material.

These things are built great very sturdy , Powedercoated the finsh is really nice can’t wait to see how well they work .. good deal right here …

it does fit and it does work.

UPDATE: I originally only gave these mounts a 2-star rating because I was unable to put a fairly standard-style light on them, but since then I've found some spot ditch lights that work perfectly with these mounts, so I'm bumping this up to a 4-star rating keeping the stipulation that these will only work with certain lights. When the hood is fully open, they clear both the windshield wipers and the windshield. Now I can really appreciate the low-profile aspect of them.ORIGINAL REVIEW:I was real excited to put these on my Ranger since I had some ditch lights, similar to the round-back Nilight ditch lights you can find here on Amazon, ready to mount and wire up.Installation ---I was nervous about messing with the hood alignment when installing these, so I slowly did each side trying to keep one bolt semi-tight as we went. Installation wasn't too bad and the hood alignment didn't change at all, but the slots for these mounts were a little large, so I put a washer on each bolt that was lightly larger than the nut to increase the surface area holding things tight. If I was going to keep these on, I'd most likely get a larger heavy-duty washer. Last thing I want is to be driving down the highway and my hood starts flapping around.Fitment ---After putting them on, it slightly hit the plastic on the passenger side when the hood was fully open and had a little more space on the drivers side. I tried re-adjusting, but I couldn't give it any bigger gap. They actually follow the contours of the hood very nicely. Without lights on them, if you weren't looking for them, you'd completely miss them, especially on my black Ranger.Mounting lights ---It was a tight fit mounting the lights on and I was ready to shorten the bolt on them to make sure there was enough clearance to it wouldn't tear up the plastic piece below over time, but I gave up after realizing that I wouldn't be able to open the hood more than 1/4th of the way since the lights hit the windshield and wiper blades. If these mounts had more height or curled back over on the hood, there'd be no problem, but with lights that have any part of them to the back of the mounting bolt, you might have issues fully opening your hood.Summary ---If you want some low-profile and solid ditch light mounts for your Ranger _and_ you have shallow lights or lights with the bulk of them towards the front of the mount, then these might work for you. As for me, unless I'm able to bend them a bit without them cracking, they're not going to work.