Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Rückkappen für WP-9 WP-20 WP-25 Paket enthält unten 10 Stück
Lange WIG-Rückkappe Ref.-Nr.: 41V24
Dieses Set passt für alle luftgekühlten Brenner der Serie 9 und wassergekühlten Brenner der Serie 20,
einschließlich der Brenner Lincoln PTA-9 und PTA-20, der Brenner Miller Diamondback DB9 und DB 20,
sowie der Brenner Weldcraft WP-9 und WP-20.
Graynor
Bewertet in den USA am6. November 2024
Quality product I look forward to putting to work
E.M.
Bewertet in den USA am5. Februar 2024
Only issues with these is they definitely feel fragile. If you happen to bump or drop your torch, inspect and replace it as there will most likely be a crack or chip. Other than that, packaging was great, no issues. They definitely "feel" inferior to caps you'd get from CK or your favorite local supplier. But, at least this package includes multiple back caps! Fit just fine on my WP9F torch.
jolivarez
Bewertet in den USA am29. April 2023
If you’re just starting out with TIG this is a really great kit. I love that it has four varying sizes and not two or three. I get the most use out of the smaller ones but if you’re using full length tungsten it also has you covered.The only drawback would be the little rubber O-rings wearing down but that is applicable to all torch caps so buy a 10-pack of replacement O-rings.
JAUME
Bewertet in Spanien am 16. Februar 2022
Se adapta perfectamente
Prof100
Bewertet in den USA am12. August 2020
The work perfectly with my Tig torch. However, the lengths sent were a random event. I am OK with the error. My local Miller welding shop would have charged me $11 for one. Great value.
Produktempfehlungen
