Ihr Warenkorb ist leer
Ihr Warenkorb ist leer WIG-Isolatorbecherdichtungen WIG-Brenner WP-17 18 26 Ref.-Nr.: 18CG-20
Menge: 5 Stück
Dieser Artikel passt auf alle luftgekühlten Brenner der Serien 17 und 26 und wassergekühlten Brenner der Serie 18,
einschließlich der Brenner Lincoln PTA-17, PTA-18 und PTA-26,
Miller Diamondback DB17, DB18 und DB 26,
sowie die Brenner Weld Craft WP-17, WP-18 und WP-26.
KBrown
Bewertet in den USA am2. Januar 2025
These are good Cup Gaskets for my 17 tig torch. They fit well and seal up good.
George moser
Bewertet in den USA am26. Juli 2024
They are tough to get on a ck worldwide Tig Torch without some modifications and it's the same with the ones in the kits they sell but if you buy a cheap Tig Torch off of Amazon they seem to fit the knock off torches ok so it's hard to recommend and buy at your own risk... Heat them or grind the inside a little to get them on... I would recommend for Cheap knock off ck17 torch but not for the real CK WW torch....
Creativemetalbymarcus
Bewertet in den USA am25. Juni 2024
Everything shown, everything listed shows that will fit a 17 but does not, it's meant for an 18 or 26 incorrect sizing.
Customer
Bewertet in den USA am24. März 2024
Shipped in timely fashion fit my tig torch correctly
mikeeeee
Bewertet in den USA am26. März 2021
Fits tight on the torch and seems like it’s made out of a harder plastic than my last one. I expect I’ll get a lot of heavy use out of these.
Produktempfehlungen
