Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Beschreibung:
Für die Befestigung der Kabel, Wasser-Widerstand-Design verwendet.
Spezielles Design der klemmenden sterben und Kunststoffteil, weiten Spannbereich, starke Dehnung Widerstand, keine Schäden an Kabeln und Geräten.
Ohne Demontage kann Kabel eingefügt durch direkt dann leicht angezogen werden.
Auf Maschinen Schaltkästen, Verteilern, Elektrogeräte, Maschinen, etc. anwendbar.
JR
Bewertet in den USA am29. Januar 2025
I bought these as a a replacement an M8 from another supplier, and I find that my 4.5mm insulated wire, which slides easily through the old one, does not fit through the rubber seal ring. (The plastic casings seem fine.) The ring opening diameter measures 4.1mm vs about 4.3 for the other supplier, and this is enough to make it tight on the cable so the cable cannot be slid through. In other words don't buy these if your cable approaches 4.5mm diameter, but for smaller wires it should be ok.
R.Sch.
Bewertet in Deutschland am 15. Mai 2023
Habe die Verschraubungen untypisch als Bremszug-Durchführung an einer Karosserie genutzt.Mit Bremszugdurchmesser 5mm musste allerdings das Dichtgummi raus und etwas aufgebohrt werden.Funktioniert bisher sehr gut.
Katja
Bewertet in Deutschland am 2. Februar 2021
Gutes Produkt
Nicholas
Bewertet in den USA am2. November 2021
As a strain relief for high gauge wiring, these worked very well. Running 2con 18awg thermostat wire felt close to a maximum. This project was with the SolidRemote 202U I also bought on Amazon. I ran the antenna through the strain relief (the one all the way to the right) with two 24 AWG wires, and that also felt like the maximum that could be passed through. Once the seal nut was tightened (external of the enclosure), the wires were in no way pulling on the screw-down terminal blocks inside the enclosure. For my project, you can see the retaining nuts inside the enclosure fit side-by-side, but I was able to do all the tightening from the male end of the fitting, outside of the enclosure.I took a gamble on buying these, and they worked in every way that I could've asked for, even if I had to be patient in the installation for my application.
Harald
Bewertet in Deutschland am 14. Juni 2019
Halten dicht.
Joteka
Bewertet in Spanien am 9. November 2018
prensa de plastico estanco, poco mas que decir...
Jody Knowles
Bewertet in den USA am28. August 2018
Working as expected.
Produktempfehlungen
4.49€
1 .99 € 1.99€
42.00€
17 .99 € 17.99€