Warenkorb

Ihr Warenkorb ist leer

Ihr Warenkorb ist leer

TY28 Lötfreier Stecker Buchse IP68 Wasserdichter Steckverbinder 2-9 Pin Stromstecker Buchse Schraub-Crimp Kabelsteckverbinder (9Pin 10A, Hintere Mutter)

Kostenloser Versand ab 25.99€

16.81€

7 .99 7.99€

Auf Lager

1.Farbe:Quadratisch


2.:2pin 45a


  • Die Mutter muss das Einbauloch öffnen und mit der Mutter fixieren
  • Isolator: Thermoplastischer PA66, hochtemperaturbeständig bis 200 °C; Einsatzmodus: Gewindeanschluss; Kontaktmaterial: Messing mit Goldbeschichtung; Spannungsfestigkeit: 1500 V
  • TY28 geeigneter Drahtdurchmesser: 10 ~ 15 mm; Kontaktdurchmesser: 1,8 - 3,6 mm; Steckzeit: > 500; Betriebsspannung: 380 V
  • - 25 ℃ hochwertiges PA66 Nylon, umweltfreundliches Material, 85 ℃ schwer entflammbar und hochtemperaturbeständig
  • Merkmale: Schraubverbindung, bequemer, wiederholter Gebrauch, verbesserte Effizienz. Schwer entflammbar, hochtemperaturbeständig. Vergoldete Kupfernadel



Produktdetails:
1. Ästhetisch ansprechendes Design
2. Geringes Gewicht.
3. Kunststoffgehäuse aus PSU oder PC.
4. Umfangreiche Sterilisation (über 100 Zyklen)
5. Ausgezeichnete elektrische Sicherheit (berührungs- und schaufelsicher).
6. Große Auswahl an Farben zur einfachen Identifizierung.
7. Große Auswahl an Schlüsseln, um Kreuzpaarungen zu vermeiden.
8. Ausdauer: > 5000 Zyklen.
9. Gehäusematerial: verchromtes Messing und vernickeltes Messing.
10. Montageart: Kabelhalterung.
11. Kontakt-/Einsatzmaterial: vergoldetes Phosphorkupfer
12. Kontakt-/Einsatz-Typ: Buchse auf Lötzinn / Buchse für Druck.
13. Temperaturbereich: -25 ° ~ 85 °.
IP-Schutzklasse: IP 68.


Chris
Bewertet in den USA am7. August 2024
This connector has an excellent design and is easy to use. I used it to replace a faulty connection on a Power Breezer (aka Powerbreezer is an awesome machine look them up if you need outdoor or open(i.e. well ventilated) indoor cooling, much better than a portacool or similar biggest benefit is the fan on these push air 50-80ft or more ). If anyone else uses this for the same purpose note that the wires are numbered. I was worried and color-coded each wire as I removed it from the existing connector with different colors of electric tape. I found that step unnecessary when I took the pigtail end off and noticed each wire had a number printed on each individual wire(all of the wires were black). That would have saved me considerably time as it is it didn't take long, the difficult part of replacing the connection was how short the wires on the fan side were. I was able to make the swap in less than an hour even with meticulous labeling, if I hadn't wasted time on labeling the job would have been complete in less than 30 minutes.As to the connector, the side you put the wires in is all labeled 1 through 7 and the screw connection seem solid. Time will tell but it seems to be even more well built than the connector it is replacing(military-grade waterproof Amphenol connection). I used a considerable amount of di-electric grease around the wires before using large heat shrink tubing to reduce the wiring surface area and then covering both the heat shrink tubing and the back of the fixed place connector with electric tape. I want the connection to be permanently water proof and with this connector and the method outlined I believe I have a permanent solution.I've only used it for a couple of weeks if it doesn't hold up I'll come back and update this review.
Sascha
Bewertet in Deutschland am 5. November 2024
Die Verschraubung ist schwergängig und das Material der Überwurfmutter ist sehr dünn. Es liegt leider keine Beschreibung dabei, wie man den Stecker für den Anschluss der Kabel zerlegt.
Dogstar
Bewertet in den USA am4. November 2024
I am so appreciative of screw type terminal connections. I tried soldering these multiple small wires without much success on a solder type connection. I do think solder is more reliable if you can do it well, which I can't. Does seem to reasonably sturdy and water resistant if not waterproof.
Bobby
Bewertet in den USA am19. Oktober 2024
Great that they only fit one way. Fit is secure. Screws to each other securely, just be careful to not over tight unless you want it to be permanent. Only issue is cover can easily come off, but since I don’t use it, it’s doesn’t matter. Quality is excellent. As for all outdoor electrical connections, always use dielectric grease. Done!Update. Contacted the seller to purchase female plug and male panel. They responded right away and assisted me with ordering the reverse fittings. Now I can install it as an extension within my kayak. And if something goes wrong with the wiring inside the kayak, I can always just connect the battery plug directly to the motor plug.
Anton Schwab
Bewertet in Deutschland am 18. Juli 2024
Schnelle Lieferung
Richard O
Bewertet in den USA am14. Juni 2024
It was the only 4 prong I could find anywhere. It is not a quick release as it is very difficult to disconnect. One of the rubber o-rings broke before it was installed. It says rated for 45amps (we'll see). Do not purchase if you are looking for a quick release..
Haderer Klaus Holger
Bewertet in Deutschland am 11. Juni 2024
sehr gut aber leider für mich nicht geeinet (past nicht zur Bluetti)
Brian
Bewertet in den USA am5. Oktober 2023
I bought this plug to connect electricity to an outdoor trash pump that is part of my french drain system. It's perfect for the job, and I have some confidence that it will be weatherproof. The connectors mate very tightly and are sealed with an O-ring. There is a cover for the female connector for when the male plug is not inserted, which is a nice thought but not something I will use; my pump will stay plugged in at all times unless I'm performing maintenance.The female connector is panel-mounted with a large plastic hex nut to secure it from behind, It will grip a 5/32 or maybe even 3/16" thick panel, so should work in most applications. The male plug is also well made, but the locking collar is a little cheesy to me. It has a tactile and audible locking action once it's gotten snug that seems like it might wear out pretty quickly. Like little plastic parts are rubbing across each other to make a noise that means, "Stop turning me now." Maybe it will last forever, but it's something to think about if you will connect and disconnect this on a regular basis. If I were going to be doing that, I might consider a plug with a threaded metal collar for the locking mechanism.For the cost, this is great, and it's going to do what I need it to do - provide a weatherproof connection for a three-wire 120VAC circuit and allow it to be disconnect once in awhile for service. Recommended!
Produktempfehlungen

44.29€

20 .99 20.99€

4.4
Option wählen

10.90€

4 .99 4.99€

4.3
Option wählen

3.95€

1 .99 1.99€

4.8
Option wählen