Ihr Warenkorb ist leer
Ihr Warenkorb ist leerKühlkörper und Heizblock bestehen aus hochwertigem Aluminiummaterial, das mit hoher Präzision bearbeitet wird. Bitte wissen Sie, dass dieser Heizblock für 3mm OD Patrone Temperatursensor geeignet ist
Nick
Bewertet in den USA am8. Januar 2024
Note: This is my first V6 hotend, so any below complaints may be to this specific model, or they may be to the V6 design in general. I have no way of knowing which!The entire hotend is very nicely assembled and machined, which is not always a given for clones. I had a lot of V6 hotends that I use in my traditional Ender 3 hotend, but it's nice to have something designed to fit specifically.An all-metal hotend in general is a nice upgrade, and heat creep seems minimal.My only real complaint is in the assembly. The only thing keeping the heat break from moving around is being firmly butted up against the nozzle. That means changing nozzles the heater block starts to come loose from the heatbreak. I haven't tried many nozzle changes yet, but this could prove extremely cumbersome. It also means that if the nozzle isn't the exact same length as the one you're replacing, it'll put the heater block at a different angle to get the heatbreak snugged up against the nozzle. This may not matter much since the entire design is cylindrical, so it can be easily rotated. Still not the best design choice.That being said, I'm happy with it so far, especially for the price! Great value proposition for an all-metal hotend with a well-established design.
Tex Olausson
Bewertet in Schweden am 3. Dezember 2024
It is absolut ok to my 3d printer prusa i3 mk2s
Timothy A Stiel
Bewertet in den USA am27. Oktober 2024
This hotend works great for my application with a Ender 5 Plus mod to a CoreXY conversion. Didn't want to spend a fortune buying much more expensive brands. Heats up quick and prints are consistent with no clogs as long as the chamber fan stays on constant. Will buy again if needed.
TechGuy77
Bewertet in den USA am25. Februar 2024
This V6 hotend seems a little higher quality than others I've purchased. The finish seems a little nicer plus a bi-metal heatbreak. Not sure if there is much of a difference as it still melts filament without any issues. Assembled without any issues or leaking when you cut the PTFE tube straight. If you are having leaking issues with filament then redo your PTFE tube and make sure it's 90 degree straight. Loosen your nozzle a bit and make sure the heat break is a little further into the heater block. Then finger tighten the nozzle. Then heat the hotend up to 230 for a bit and do a hot tighten of the nozzle. If done right you won't have any leaks. Leaks are usually and end user issue not the hotend itself. So far I'd recommend this V6 hotend to anyone who's in need of one. I don't suggest this as an upgrade as their is no noticeable differences from stock.
Noah
Bewertet in den USA am21. Januar 2024
This is about as close of a direct replacement as you can get without buying direct. As such you lose out on some things. The main issue is one of fitment. The heatsink is slightly undersized on the inner bowden tube area and I couldn't get my tube to fit. I ended up using my old heatsink because it was still good but it was still disappointing. Other than that I haven't noticed any other issues. It was a little hard to tighten up the heat break into the heatsink because the part where the two metals meet kept spinning, but I eventually got it tight. Overall it's an ok kit but I would probably look into official parts for my next replacements.
Mehling Kevin
Bewertet in Deutschland am 12. Juli 2024
Solides Produkt.
Produktempfehlungen
