Ihr Warenkorb ist leer
Ihr Warenkorb ist leerBronze
Bewertet in den USA am23. Februar 2025
The tool in itself is acceptable. The soldering iron heats quickly and does the job well. The inserts that are included in the kit are pretty sad, but they exist and are threaded correctly.The frame and stops are kinda janky and there aren't any instructions to speak of, but it functions and for the price, it's an excellent value.
Kelly Bellerose
Bewertet in Kanada am 13. Januar 2025
It works as intended, the tips get "stuck" on easily, had to wait for it to fully cool down then use pliers to remove the insert tip in order to change it to a different size, but being brass you have to be very careful how much pressure you use so you don't distort it.
Steve McCarley
Bewertet in Kanada am 14. September 2024
Does a great job of inserting threaded inserts into printed plastic parts with precision. And at a very reasonable price. Has all the parts you need to get started right away.
Legendary 3D
Bewertet in Kanada am 11. September 2024
I am pleased with most of this product and it performed well for the first test. Though i had a little trouble in beginning: When I went to remove my first tip for a different size tip, I find that it is stuck on! I was careful not to over tighten (knowing that heat causes expansion) and only heated it to 220 C, but I cannot remove the first tip I put on. I like the product overall but not impressed at how quickly the tip became stuck! It would have gotten 5 stars if it weren't for this problem. Overall I am satisfied and would recommend it to others. My use case is for adding inserts into 3D printed parts I'm producing.
customer
Bewertet in den USA am1. Oktober 2024
I'm actually pretty good about installing heat inserts by hand, but I had a project where I needed to install over 50 - 4mm inserts at the same time, and I decided to see if this would cut the my labor down, and just make it less tedious. This heat press machine actually saved me a lot of time, and fatigue while completing, I actually had some fun doing it, instead of kind of dreading it.Assembly wasn't too difficult, it was easier than say, putting together some of that DYI furniture.With the included digital iron, you can set the temp precisely, and it holds that temp quite well. Being able to set the depth with a stopper means your inserts are going to be way more consistent than you can do by hand!! I like that I can just leave my main sized tip on the included iron, where I then have my previous iron available to use for quick one-offs that I need to install by hand.The vertical rail action is pretty smooth, but you kind of need to find the "sweet-spot" on where you push down on the bar, else it can bind up, but that only took a few seconds of testing before I put a part in to figure out.The different sized tips are also included & can be unscrewed and changed out without removing the soldiering iron, but since they are super hot, you'll have to wait for them to cool down before you can do so. That fact alone means that if you are doing 5 inserts of 5 different sizes, it will be a lot quicker to do them by hand. Where 5 of the same size, this is where it really shines! Note: the soldiering iron can easily be removed and used by hand also, so if you don't already have one, this is versatile enough to use it either way! Win-Win!I can say I highly recommend this for any project where you need to do multiple, consistent inserts. Once you have put it together, you can pull it out and be knocking them out within minutes.
Produktempfehlungen
