Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDominiek
Bewertet in Frankreich am 7. Februar 2025
Works perfect for Surface, tablets end phones
Wilhelm+Alla
Bewertet in Deutschland am 20. März 2025
Alles gut
Maestripieri Giorgio
Bewertet in Italien am 28. Dezember 2024
Perfetto
Matthew Fields
Bewertet in den USA am28. Juli 2024
I used this PoE injector to power an Aruba 345 Access Point. I have been running this setup for some time now, and have had no issues. It fit perfectly into my network cabinet. Seems well made, and the price is great. No complaints here, I would definitely recommend this PoE Injector.
J. Hansen
Bewertet in den USA am5. November 2023
I picked up a Yeacomm 5G outdoor modem, and since it's powered by POE, I wanted a good solution. While I do have a POE switch, I was using it in another location, and didn't want to move it to where I'd need it for the modem. I didn't even realize a POE injector existed, so just happened across it. Since the 5G modem doesn't give me speeds over gigabit, this looked like a great solution.This literally was pretty much plug and play. Nothing special. Just plugged in the power cable, attached one end to the POE modem and the other ethernet jack to my LAN. The injector is clearly labeled, so it's really easy to determine which port is what. The instant I plugged in the POE modem, it fired on up, and began working. I didn't lookup the power requirements for the modem, but clearly 15W is enough to power it. It's been working great ever since. At this point, it's only been a few days, but this really is a great solution.Price wise, under $12 is hard to beat for this, making it an even better option in my mind. If you're in the market for a smaller option versus a switch to power a POE device, this is one you should definitely look at.
JHoney
Bewertet in den USA am25. Oktober 2023
I used this with a POE to USB C PD supply.edit: I've since bought the 30W version. It has the same outer case, different sticker. I don't feel like cracking it open, but I did compare weights. The 15W was 107g (including the glue I added), the 30W is 129g so there's certainly something extra. The rest of this review applies to the 15W version.My PD supply could draw up to 23W which is too much for this device, but it did let me see how it handled being overloaded. It actually ran at 20W for 10-15 minutes before it started resetting. It would come back up and reset almost immediately after that. The device was warm, but it didn't feel extreme.Efficiency is OK, not great. Some examples at 20W output (yes, this is over maximum) it drew 28W from the wall. A more reasonable load of 7W drew around 11W from the wall. Being a low power device this probably isn't too bad.The hardware seems pretty nice. The circuit board looks like a quality design. It has expected protection components. The high-low voltage separation looks great. Capacitors, inductors, and transformers are all siliconed in place nicely. I don't care for the included cord. It's quite thin, and marked 2x0.5mm². Adequate, but I'm used to bulker cords that are better protected from cuts and abrasion.When running with the case open temperatures peaked around 45C (with a normal load). The hottest components seemed to be a couple different diodes, and the main transformer. I didn't see any issue.
Produktempfehlungen